Terminal Access

This form shows GajShield Administration console. It will allow only a set of commands to run, which are mentioned below. You could also see the available command list by typing 'help' in gajshield administration console.

Terminal

firewallstart	Install all firewall rules
firewallstop	Remove all firewall rules, makes the system open
help	Display list of valid commands
history	Show recenly used commands
ipconf	Configure interface IP address
ping	Send ICMP ECHO_REQUEST to network hosts
resetdefault	Reset to dafault settings
restartnetwork	Restart the network
route	Show or manipulate the IP routing table
tcpdump	Dump traffic on a network
traceroute	Print the route packets take to network host